How to Clone Medical Cannabis Plants.

How to Clone Medical . no recibe cobertura independiente adecuada en la mayoría de recursos sobre cannabis. Recibe un párrafo dentro de una guía general, lo cual raramente es suficiente cuando realmente estás lidiando con ello durante un cultivo activo y necesitas tomar una decisión.

Cuándo Tiene Sentido Clonar — Y Cuándo las Semillas Son la Mejor Opción

Cloning preserves the exact genetic expression of a specific plant — the same terpene profile, growth habit, potency, and phenotype, replicated identically. If you have found a phenotype you love during a seed run, cloning lets you keep it indefinitely. The tradeoff: clones carry the mother's biological age (they do not "reset" like seeds), do not develop taproots (which limits outdoor vigor), and require maintaining a mother plant or access to a reliable clone source.

Starting from semillas feminizadas gives you genetic diversity (every seed is a slightly different phenotype), taproot development, fresh vigor, and no dependency on maintaining a mother. Most home growers benefit from starting with seeds to explore a strain's phenotype range, identifying their favorite, and then cloning that specific plant for subsequent runs.

Taking Cuttings: Technique That Determines Success Rate

Select a branch tip 4-6 inches long from the lower-middle section of a healthy, non-stressed mother in vegetative state. Cut at a 45-degree angle just below a node using a clean, sharp razor blade — not scissors, which crush the stem and reduce uptake. Remove lower leaves immediately, leaving 2-3 sets of upper leaves. Trim the remaining leaf tips by 50% to reduce transpiration demand while the cutting has no roots.

Dip the cut end in rooting hormone — gel formulations maintain contact better than powder. Insert into pre-moistened rooting medium (rockwool cubes, peat plugs, or rapid rooters). Place inside a humidity dome at 75-80°F with 80-90% RH. Roots appear in 7-14 days. Light should be gentle — a T5 fluorescent or low-intensity LED. Too much light drives photosynthesis that the rootless cutting cannot support.

Por Qué Fallan los Clones: Las Cinco Causas Más Comunes

Cutting from stressed mother material: A mother plant in nutrient deficit, heat stress, or mid-flower produces cuttings with low energy reserves that struggle to root.

Air exposure before medium placement: An air bubble in the stem blocks water uptake. Cut underwater or immediately place the cut end in rooting gel/water.

Low humidity: Without roots, the cutting relies on foliar moisture absorption and reduced transpiration. Below 70% RH, it dries out faster than it can hydrate.

Contamination: Reused trays, dirty razor blades, or old rooting medium introduce pathogens that attack the vulnerable cut site.

Impatience: Checking cuttings daily, pulling them out to inspect roots, and handling them introduces stress and contamination. Set and forget for 7 days minimum.

Managing Clones After Rooting

Once roots are visible (white tips emerging from the medium), gradually reduce humidity over 3-5 days by opening dome vents. Transplant into small containers with your chosen medium. Begin feeding at 25-30% strength. Light intensity can increase to seedling levels (300 PPFD). Treat rooted clones like seedlings in terms of feeding and environmental sensitivity until they show active new growth — typically 5-7 days after transplant.

Preguntas Frecuentes

How old should a mother plant be before taking clones?

At least 2 months from seed with 6+ nodes of growth. Young mothers produce weak cuttings with low energy reserves.

Can I clone from a flowering plant?

Yes (called "monster cropping"), but success rates are lower and the clone takes 2-3 weeks longer to revert to vegetative growth. Rooting from a veg-stage mother is far more reliable.

How many clones can one mother support?

A healthy mother with 10+ branches can provide 6-10 cuttings every 2-3 weeks without significant stress, as long as she is well-fed and has time to regrow between cuts.